What is a centrifugal compressor
A centrifugal compressor is a dynamic machine in which gas is accelerated by an impeller and then decelerated in a diffuser, converting velocity into pressure. Several stages in one casing give a pressure ratio of up to 25 and a discharge pressure of up to 15 MPa at flows up to 300,000 Nm³/h; drive power up to 30 MW from a steam turbine, gas turbine or electric motor. Built to API 617.
Key facts
- The impeller accelerates the gas and the diffuser turns velocity into pressure.
- Up to 15 MPa, 300,000 Nm³/h and a pressure ratio of 25.
- Drivers up to 30 MW: steam or gas turbine, electric motor.
- Built to API 617.
- Needs anti-surge protection.
How it is built
A rotor with impellers on one shaft, a stator with diffusers and return channels, a horizontally split casing (for low and medium pressures) or a vertically split barrel casing (for high pressures and light gases), journal bearings, dry gas seals at the shaft ends, a lube oil system. The train is delivered on a common baseplate with the driver, a gearbox where needed and a control system with anti-surge protection.
Ratings and gases
Discharge pressure up to 15 MPa, flow up to 300,000 Nm³/h, pressure ratio up to 25, drive power up to 30 MW. Gases: hydrocarbons, syngas, CO2, ammonia, ethylene, propylene, hydrogen-rich mixtures, air and nitrogen. For hydrogen at up to 15 MPa multistage machines with a low head per stage are used, because a light gas is hard to compress dynamically.
Where it is used
Oil and gas production and gas transmission, LNG plants (feed gas and boil-off gas compressors), refining and petrochemicals, ammonia and methanol production, metallurgy, air separation. The team’s references are the boil-off gas compressors at Yamal LNG and the erection and commissioning of the Arctic LNG 2 compressors.
Control and protection
Output is controlled by driver speed, inlet guide vanes or throttling; the anti-surge system keeps the operating point to the right of the surge line. Rotor vibration and axial position, bearing temperatures and seal gas flow are monitored.
Maintenance
Inspections by operating hours, replacement of dry gas seals and bearings, flow-path overhaul, rotor balancing, alignment with the driver, anti-surge tuning, spare parts for Siemens Energy STC, Dresser-Rand Datum, Kobelco and Hanwha machines.
Questions and answers
How does a centrifugal compressor work in simple terms?
A fast-spinning impeller flings the gas from the centre to the rim and accelerates it, while a stationary diffuser slows the flow and turns velocity into pressure. The gas then passes through a return channel to the next impeller. Several such stages in one casing raise the pressure tens of times.
How does a centrifugal compressor differ from a reciprocating one?
A centrifugal compressor works with a continuous flow: it is compact, runs for years without stops and suits large flows, but needs surge protection. A reciprocating compressor compresses gas in portions: it reaches 50 MPa at moderate flow and handles light gases well, but needs regular valve and ring replacement.
What data are needed to select a centrifugal compressor?
Gas composition, flow, suction pressure and temperature, discharge pressure, the range of operating modes, driver type and site conditions. They are collected in an API 617 data sheet, from which our engineers select the machine and prepare a technical and commercial proposal.
Related terms
Updated: 2026-09-23