What is the rotor of a turbine or compressor

The rotor is the rotating part of a turbine or compressor: a shaft with shrunk-on or integrally forged impellers, discs and blades, supported by bearings. Its condition determines the vibration, clearances and life of the whole machine; the rotor is balanced, its critical speeds and axial position are monitored, and during repair it is restored or replaced by an exchange rotor.

Key facts

  • A shaft with impellers, discs and blades running in bearings.
  • Operating speed must be 15–20 % away from critical speeds.
  • Unbalance is the main source of once-per-revolution vibration.
  • Vibration and axial position are monitored by an API 670 system.
  • An exchange rotor shortens downtime during a major overhaul.

Design

A monobloc rotor — discs machined from a single forging (steam and gas turbines); a built-up rotor — impellers shrunk or keyed onto the shaft (centrifugal compressors); a welded rotor — discs welded together (large gas turbines). Blades are held in disc slots by fir-tree or T-shaped roots. The thrust collar takes the axial force, the shaft journals run in journal bearings, and seals and couplings sit at the shaft ends.

Critical speeds and balancing

At critical speeds the natural bending vibrations of the rotor coincide with the running speed and vibration rises sharply; the operating speed must be 15–20 % away from them. Unbalance is the main source of once-per-revolution vibration; the rotor is balanced on a machine during manufacture and repair and in situ in its own bearings by adding or removing mass in the correction planes. Flexible rotors are balanced in several planes at operating speed.

Monitoring in service

Proximity probes measure the relative vibration of the journals and the axial position of the rotor, sensors on the bearing housings measure absolute vibration; a vibration monitoring system to API 670 alarms and trips the machine when limits are exceeded. Rising vibration, phase change and axial shift point to unbalance, rubbing, bearing defects or surge.

Repair and spare parts

Non-destructive testing of journals, slots and blades, restoration of fits, replacement of blades and discs, shaft straightening, balancing. An exchange rotor shortens downtime during a major overhaul. Rotors and their parts for Siemens Energy and Dresser-Rand compressors and steam turbines are supplied as spare parts with confirmed origin.

Questions and answers

What is rotor balancing?

Correcting the uneven distribution of mass about the axis of rotation. The rotor is spun on a balancing machine or in situ in its own bearings, vibration and its phase are measured, and mass is added or removed in the correction planes. Flexible rotors are balanced in several planes at operating speed.

Why does rotor vibration increase?

Causes include unbalance from wear or deposits on the blades, misalignment with the driver, bearing defects, seal rubs, loosened fits and surge. Rising vibration, phase change and axial shift help to find the cause — the job of vibration diagnostics and balancing.

What is an exchange rotor?

A new or refurbished rotor prepared in advance and installed in place of the one removed during a major overhaul. The removed rotor is then repaired without haste and returned to the spares pool. This cuts downtime by the time of the rotor repair, usually the longest part of the job.

Related terms

Updated: 2026-09-23

CallSend a request