What are dry gas seals
Dry gas seals are non-contacting mechanical face seals for the shaft of a centrifugal compressor in which the gap between the rotating and stationary rings is maintained by a gas film a few micrometres thick. They replace oil seals: they need no seal oil system, consume almost no power and keep oil out of the process gas.
Key facts
- A non-contacting face seal with a gas film a few micrometres thick.
- Replace oil seals and keep oil out of the process gas.
- The tandem arrangement is standard for hydrocarbon compressors to API 617.
- The main condition indicator is the primary seal leakage flow.
- Replaced as a cartridge without dismantling the compressor.
How they are built
A rotating ring with spiral or other grooves and a stationary ring pressed by springs. As the shaft turns, the grooves pump gas into the gap and create a pressure that pushes the rings apart, forming a stable gas film. Seals are single, tandem (two in series with an intermediate labyrinth) or double with barrier gas; tandem is the standard for hydrocarbon compressors to API 617.
Seal gas system
Clean, dry process gas or nitrogen is supplied to the seal at a pressure above that behind the impeller; filters, regulators, heaters and flow meters control its quality and flow. The primary seal leakage is vented to the flare or vent stack, and its flow rate is the main indicator of seal condition. A separation seal on the bearing side keeps oil away from the gas.
Typical problems
Contamination and condensate in the seal gas, reverse rotation and surge, standstill under pressure without seal gas supply, incorrect assembly during replacement. Symptoms are rising leakage, temperature and vibration. With correct operation the life is years; replacement is done as a cartridge without dismantling the compressor.
Where it appears on this site
Supply of dry gas, barrier and labyrinth seals for Siemens Energy, Dresser-Rand, Kobelco and Hanwha centrifugal compressors, selection by machine model, replacement and commissioning of seal gas systems on site; API 617 centrifugal compressors packaged with lube oil systems and dry gas seals.
Questions and answers
Why have dry gas seals replaced oil seals?
Oil seals need a separate oil system with pumps and degassing, consume power and let oil into the process gas. Dry gas seals run on a thin gas film, consume almost no power and do not contaminate the gas, so they have become the standard for new centrifugal compressors.
What most often causes dry gas seal failure?
Contamination and condensate in the seal gas, reverse rotation of the rotor on shutdown, surge and standstill under pressure without seal gas supply. Seal reliability therefore depends not only on the cartridge but also on the gas conditioning system — filters, heaters and regulators.
How is a replacement dry gas seal selected?
By compressor model and serial number, the seal drawing or datasheet, gas composition and operating pressures. Energy Management supplies dry gas, barrier and labyrinth seals for Siemens Energy, Dresser-Rand, Kobelco and Hanwha compressors — a request can be sent from the dry gas seals page.
Related terms
Updated: 2026-09-23