What is SF6 gas
SF6 gas is sulphur hexafluoride: a non-flammable, chemically inert gas with a dielectric strength about 2.5 times that of air and a high arc-quenching ability. It serves as the insulating and arc-quenching medium in high-voltage circuit breakers, GIS and gas-insulated bus ducts.
Key facts
- Chemical formula SF6 (sulphur hexafluoride).
- Dielectric strength about 2.5 times that of air.
- Leakage limit for GIS: no more than 0.1 % a year per gas compartment.
- Venting is not allowed: the gas is recovered, cleaned and reused.
- For −60 °C an SF6–CF4 mixture or tank heaters are used.
Why it is used
The high dielectric strength shortens insulating distances and shrinks the apparatus: GIS takes 25–30 times less space than air-insulated switchgear. When an arc is interrupted, SF6 removes heat intensively and quickly restores the strength of the gap, and in the absence of moisture the decomposition products mostly recombine into SF6. The gas does not age and the enclosures are sealed, so the apparatus lasts more than 50 years.
Properties
Molecular mass 146, about five times heavier than air; colourless, odourless and non-flammable; non-toxic when pure, but it displaces air and collects in pits and low points. The electronegativity of the molecule — its ability to capture free electrons — gives the high dielectric strength. Operating pressure in the apparatus is usually 0.4–0.7 MPa.
Leak control and gas handling
SF6 is one of the strongest greenhouse gases, so leakage is regulated and monitored. For GIS the norm is no more than 0.1 % a year from each gas compartment. Density is monitored by density sensors with alarm and lock-out; when the pressure drops the apparatus is topped up and the leak is located with a leak detector. During repairs the gas is pumped into cylinders, cleaned and reused; release to the atmosphere is not allowed. Decomposition products formed after short-circuit interruptions are toxic, so work inside a compartment starts only after evacuation and ventilation.
Operation at low temperatures
As the temperature falls, SF6 at operating pressure may liquefy and lose its insulating properties. For areas down to −60 °C dead-tank circuit breakers use a mixture of SF6 with tetrafluoromethane (CF4) or tank heaters; GIS is installed in heated buildings.
Where it appears on this site
SF6 is the medium of the 72.5–550 kV dead-tank and live-tank circuit breakers and of the 145, 245 and 330/550 kV GIS bays; the company’s test laboratory tested 400 kV SF6 bus ducts at the Akkuyu NPP.
Questions and answers
Is SF6 dangerous to people?
Pure SF6 is non-toxic, but it is five times heavier than air, displaces it and collects in pits and cable trenches, so GIS rooms have ventilation and gas detectors. Decomposition products formed after short-circuit interruptions are toxic: work inside a compartment starts only after the gas is evacuated and the space ventilated.
Why is SF6 used in 110–500 kV circuit breakers?
It combines high dielectric strength with fast arc quenching: at current zero the gas removes heat and restores the strength of the gap. This makes SF6 breakers and GIS compact and lets them run for more than 50 years without replacing the gas.
What is done when SF6 leaks?
The density monitor raises an alarm when the pressure drops and locks the apparatus out if it keeps falling. The leak is located with a leak detector, the seal is restored and the compartment is topped up to rated density. Gas recovered during repairs is cleaned and reused.
Related terms
Updated: 2026-09-23