What is a gas microturbine
A microturbine is a small gas turbine unit of 110 to 1,966 kW with a high-speed generator on the same shaft as the compressor and turbine. It runs on natural and associated gas, biogas and industrial waste gases and supplies electricity and heat for distributed generation; NOx emissions no more than 25 ppm, noise no more than 85 dB(A).
Key facts
- Output from 110 to 1,966 kW in three series: 135, 390 and 2100.
- Generator on one shaft with the compressor and turbine, no oil or gearbox.
- Fuels: natural and associated gas, biogas, waste gases.
- NOx no more than 25 ppm, noise no more than 85 dB(A).
- Versions: recuperated for minimum fuel, simple cycle for up to 7.7 t/h of steam.
How it is built
A radial compressor, a combustor, a radial turbine and a generator on a common shaft with air or magnetic bearings, without oil or a gearbox; the speed is tens of thousands of rpm, and power electronics convert the generator output to 50 Hz. In the recuperated version the exhaust gases preheat the air before the combustor, reducing fuel consumption; in simple cycle all the exhaust heat goes to a heat recovery boiler.
Series and ratings
Three series: 135 (110–128 kW), 390 (346–396 kW) and 2100 (1,721–1,966 kW). Two versions: simple cycle — maximum steam, up to 7.7 t/h; recuperated — minimum fuel, 51–626 Nm³/h. NOx ≤ 25 ppm (50 mg/m³), noise ≤ 85 dB(A). Series 135 has been in commercial operation since 2018 with more than 130,000 hours without remarks; series 2100 runs on various fuels including industrial waste gases.
Where it is used
Distributed power supply and waste heat recovery: industrial sites, oilfields with associated gas, wastewater plants and landfills with biogas, sites without a reliable grid. Small size and weight, mobility, scalability by adding units, long operation without maintenance and remote monitoring.
How it differs from a gas engine genset
A gas engine genset has a higher electrical efficiency — more than 41 % against a typical 30 % for a microturbine — but the microturbine has fewer moving parts, needs no oil or coolant, gives a high-temperature exhaust for steam production and is more tolerant of gas composition. The choice depends on the ratio of electricity to heat demand and on the fuel.
Questions and answers
What makes a microturbine better than a gas engine genset?
It has fewer moving parts, no oil or coolant, a high-temperature exhaust that can raise steam, and it tolerates gas composition better. A gas engine genset wins on electrical efficiency — over 41 % against a typical 30 %. The choice depends on the ratio of power to heat demand and on the fuel.
Can a microturbine run on associated gas and biogas?
Yes. Microturbines run on natural and associated gas and on biogas from wastewater plants and landfills, and the 2100 series also on industrial waste gases. That is why they are used at oilfields and sites where the gas would otherwise be flared.
Which microturbine series does the company supply?
Three series: 135 (110–128 kW), 390 (346–396 kW) and 2100 (1,721–1,966 kW), recuperated or simple cycle. The 135 series has been in commercial operation since 2018 with more than 130,000 hours. Ratings are on the gas microturbines page.
Related terms
Updated: 2026-09-23