What is DLE
DLE (dry low emissions) is “dry” low-emission combustion in a gas turbine: the fuel is premixed with excess air and burns as a lean mixture at a reduced flame temperature, without water or steam injection. Nitrogen oxide emissions drop to 15–25 ppm at 15 % O2 while CO stays low.
Key facts
- A lean premixed mixture burns at a lower flame temperature.
- NOx is about 25 ppm at 15 % O2 without water or steam injection.
- Burners work in stages: pilot and main.
- Stable operation is usually above 50–60 % load.
- Combustion tuning is repeated after burner replacement and fuel changes.
How it works
Nitrogen oxides form in the high-temperature zone of the flame. In a DLE combustor the fuel is injected through many nozzles into the air stream and mixed with it before the combustion zone. The lean homogeneous mixture burns at a lower temperature than a diffusion flame, so less NOx forms. The burners operate in several stages: the pilot stage stabilises the flame at low loads and the main stages come in as the load rises.
What it is for
Compliance with emission limits without consuming water or steam and without treatment plants for them — unlike the “wet” NOx suppression methods. Typical values for modern turbines are NOx 25 ppmvd at 15 % O2 on natural gas; the 42.2 MW machine with water injection gives 42 ppm. CO must be controlled as well: an over-lean mixture does not burn out completely, so the stable operating window is narrow.
Combustion tuning
Fuel split between burner stages, air temperature and pressure and gas composition affect flame stability and pressure pulsations in the combustor. Combustion tuning is done from measurements of emissions and combustor dynamics over the load and ambient temperature range; it is repeated after burner replacement, a change of fuel composition and after inspections.
Limitations
A narrow stable combustion range: at part load emissions rise, so DLE machines are kept above 50–60 % load. Sensitivity to fuel composition — a change in Wobbe index requires retuning. Thermoacoustic pulsations from wrong tuning destroy liners, so combustors are fitted with pulsation sensors.
Where it appears on this site
42–308 MW gas turbines with DLE, microturbines with NOx ≤ 25 ppm, the combustion tuning service and gas turbine service.
Questions and answers
How does DLE differ from water or steam injection?
Wet methods lower the flame temperature by injecting water or steam into the combustor, which needs water treatment and a constant water supply. DLE achieves the same with a lean premixed mixture and no water or steam. For example, the 42.2 MW machine with water injection gives 42 ppm NOx, while DLE machines give about 25 ppm.
Why do emissions rise at part load?
To keep the flame stable as fuel flow falls, the control system shifts the burners to modes with a larger pilot fuel share. The pilot flame burns hotter, so more NOx forms, and an over-lean mixture burns incompletely and produces CO. That is why DLE machines are kept above 50–60 % load.
When is combustion tuning needed?
After replacing burners and liners, when gas composition or the Wobbe index changes, after inspections and when emissions or pulsations rise. Tuning is based on actual measurements of emissions and combustor dynamics — see combustion tuning.
Related terms
Updated: 2026-09-23