What is a diaphragm compressor

A diaphragm compressor is a positive-displacement machine in which the gas is compressed by a metal diaphragm flexed by a hydraulic drive: the gas is separated from the oil and does not contact the atmosphere, so compression is free of contamination and leakage. Discharge pressure up to 45 MPa at flows up to 1,000 Nm³/h and power up to 200 kW — for pure, hazardous, rare and corrosive gases.

Key facts

  • Gas is compressed by a hydraulically driven metal diaphragm.
  • The gas is isolated from oil and atmosphere — no contamination or leaks.
  • Up to 45 MPa, 1,000 Nm³/h and 200 kW.
  • Leak-detection channels between diaphragms signal damage.
  • Used for hydrogen and rare, toxic and corrosive gases.

How it is built

A set of three thin diaphragms is clamped between the gas plate and the oil plate; the piston of the hydraulic section flexes the diaphragms through the oil towards the gas plate and displaces the gas through the valves. Between the diaphragms are leak-detection channels: if a diaphragm fails, the pressure in them rises and an alarm is raised. A head with a vertical or horizontal split is chosen for maintenance access; two or three stages with intercooling.

Ratings and gases

Discharge pressure up to 45 MPa at flows up to 1,000 Nm³/h, drive power up to 200 kW. Gases: hydrogen, CO2, hydrogen chloride, helium and other rare gases, hazardous and corrosive gases; the gas-side materials are stainless steels and alloys chosen for the medium.

Where it is used

Hydrogen filling stations and hydrogen energy, semiconductor and pharmaceutical production, laboratories and cylinder filling with high-purity gases, recovery and recirculation of expensive gases, chemical plants with toxic media. Where gas purity and leak-tightness are essential, a diaphragm compressor replaces a reciprocating one.

How it differs from a reciprocating compressor

A reciprocating compressor gives a higher flow and pressure up to 50 MPa, but its rings and packings allow traces of oil and some leakage. A diaphragm compressor is fully leak-tight and oil-free on the gas side but limited in capacity and needs periodic replacement of the diaphragm set. For hydrogen both types are used depending on the required flow.

Questions and answers

Why are diaphragm compressors used for hydrogen?

Hydrogen must stay clean, free of oil traces, and leaks of a light flammable gas are unacceptable. A diaphragm compressor is fully leak-tight and oil-free on the gas side, so it suits hydrogen energy and filling stations; the models on this site reach 45 MPa. See hydrogen compressors.

How often are the diaphragms replaced?

The diaphragm set is a consumable: it is replaced to the manufacturer’s schedule or when the leak-detection system trips. Its life depends on pressure, the number of cycles and gas purity. If one diaphragm fails, the pressure in the channels between the diaphragms rises and the alarm sounds before gas can escape.

How does a diaphragm compressor differ from a reciprocating one?

A reciprocating compressor gives a higher flow and up to 50 MPa, but its rings and packings allow traces of oil and some leakage. A diaphragm compressor is fully leak-tight and oil-free on the gas side but limited in capacity — up to 1,000 Nm³/h — and needs periodic replacement of the diaphragm set.

Related terms

Updated: 2026-09-23

CallSend a request